Scion 2004 xB Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Autos Scion 2004 xB herunter. INSTALLATION INSTRUCTIONS Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 9
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Equipped with AEM
®
Dryow™ Filter
No Oil Required!
INSTALLATION INSTRUCTIONS
PART NUMBER: 21-567
2006 SCION xB L4-1.5L
2004-2005 SCION xB L4-1.5L C.A.R.B. E.O. # D-670-2
AEM Induction Systems 1 (800) 992-3000 WWW: http://www.aemintakes.com
AEM
®
bypass valves are not compatible with this intake system (part number 21-567)
DO NOT attempt to install an AEM bypass valve on this intake system!
See aemintakes.com for CARB status on each part for a specific vehicle
LEGAL IN CALIFORNIA ONLY FOR RACING VEHICLES
WHICH MAY NEVER BE USED, REGISTERED
OR LICENSED FOR USE UPON A HIGHWAY.
Seitenansicht 0
1 2 3 4 5 6 7 8 9

Inhaltsverzeichnis

Seite 1 - INSTALLATION INSTRUCTIONS

Equipped with AEM® Dryow™ FilterNo Oil Required!INSTALLATION INSTRUCTIONSPART NUMBER: 21-5672006 SCION xB L4-1.5L 2004-2005 SCION xB L4-1.5L C.A

Seite 2

2 Description Qty. Part NumberPARTS LISTAir Filter Assy. 2.25 x 5” Dry Ele. 1 21-200DKInlet Pipe 1 2-554Elbow, 2.25” 10 Degree 1 5-221Hose; 5/8”ID

Seite 3

31. Preparing Vehicle a. Make sure vehicle is parked on level surface. b. Set parking brake. c. If engine has run in the past two hours, let it co

Seite 4

4e. Loosen the hose clamp at the throttle body. Re-lease the two spring clips at the front edge of the air cleaner cover. Remove the air cleaner cove

Seite 5 - intake system

53. Installation of AEM® intake system. a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until i

Seite 6

6d. Install the supplied rubber mount bracket as shown and secure the resistor ballast using the original bolts. Install the supplied rubber mount usi

Seite 7

7j. Adjust the inlet pipe and coupler for best tment. Make sure the AEM® intake system does not come into contact with the vehicle anywhere. Adjust

Seite 8

8p. Place a small screwdriver in the slot of the clip and gently pry downwards. Split the housing of the clip open. Slide the clip down the wire har

Seite 9 - 6. Service and Maintenance

9AEM Air Intake System Warranty PolicyAEM® warrants that its intake systems will last for the life of your vehicle. AEM will not honor this warranty d

Kommentare zu diesen Handbüchern

Keine Kommentare